Electrical & Power Control

Fuse Inspection

9steps
~54min
4/5difficulty
Done 0 of 9

How To Check

  • If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.

  • Use fuse of specified rating. Never use fuse of more than specified rating.

  • Do not partially install fuse; always insert it into fuse holder properly.

  • Remove fuse for “ELECTRICAL PARTS (BAT)” if vehicle is not used for a long period of time.

EXTENDED STORAGE FUSE SWITCH (IF EQUIPPED)

The following switch may be mounted on the fuse block (Junction Box) for transportation and storage.

Extended storage fuse switch
Type A Type B Type C

Remove the extended storage fuse switch if it causes the interference when checking fuses.

How To Extended Storage Fuse Switch ON/OFF

  • Type A

    • To turn the extended storage fuse switch OFF, pull it up in direction as shown in the figure.

    • To turn the extended storage fuse switch ON, press it in direction as shown in the figure.

  • Type B

    • To turn the extended storage fuse switch OFF, hold of the switch and pull up in direction as shown in the figure.

    • To turn the extended storage fuse switch ON, press it in direction as shown in the figure.

  • Type C

    • To turn the extended storage fuse switch OFF, pull it up in direction as shown in the figure.

    • To turn the extended storage fuse switch ON, press it in direction as shown in the figure.

How To Remove Extended Storage Fuse Switch

Type A

  1. Turn the ignition switch OFF.

  2. Turn the extended storage fuse switch OFF.

  3. Press pawl and tilt to disengage the extended storage fuse switch. Press pawl and tilt to remove the extended storage fuse switch.

Type B

  1. Turn the ignition switch OFF.

  2. Turn the extended storage fuse switch OFF.

  3. Hold and pull up the extended storage fuse switch hard in direction.

Type C

  1. Turn the ignition switch OFF.

  2. Turn the extended storage fuse switch OFF.

  3. Hold and pull up the extended storage fuse switch hard in direction.