Suspension

Id Registration Cannot Be Completed

~2min read

Description

The ID of the tire pressure sensor installed in each wheel cannot be registered in the tire pressure monitoring system. Inspect the tire pressure sensor or the tire pressure monitoring system circuit.

Diagnosis Procedure

CHECK TIRE PRESSURE SENSOR INSTALLATION

Check visually that tire pressure sensors are installed to each wheels correctly.

  • Tire pressure sensor(s) are not installed.

  • Tire pressure sensor(s) of other cars are installed.

Are the genuine NISSAN tire pressure sensors are installed correctly?

YES>>

GO TO 2.

NO>>

Replace and/or Install tire pressure sensor(s).Refer to TIRE PRESSURE SENSOR : Removal & Installation. GO TO 3.

CHECK TIRE PRESSURE SENSOR ACTIVATION TOOL

Check tire pressure sensor activation tool.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace the battery of tire pressure sensor activation tool or repair/replace the tire pressure sensor activation tool.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Description.

  • Never register ID in a place where radio waves are interfered (e.g. radio tower).

  • Never register ID in a place close to Nissan Armada vehicles including TPMS.

Is tire pressure sensor ID registration completed?

YES>>

INSPECTION END

NO>>

GO TO 4.

CHECK TIRE PRESSURE SIGNAL

Change the work location and perform ID registration again.

  • Rotate tire by 90°, 180°, or 270°. (This step is to change tire pressure sensor position.)

  • Open the door close to the tire of which ID registration is ongoing.

*: Radio wave reception condition depends on vehicle architecture (e.g. body harness layout, tire wheel design) or environment.

When ID registration is performed, which wheels do not react?

All wheels react and ID registration is possible.>>

INSPECTION END

Only certain wheel(s) do not react.>>

Replace applicable tire pressure sensor. Refer to TIRE PRESSURE SENSOR : Removal & Installation.

All wheels do not react.>>

Replace the BCM. Refer to Removal and Installation.