Suspension
Tire Pressure Monitoring System Symptom
In this manual: Suspension
~2min read
Symptom Table
LOW TIRE PRESSURE WARNING LAMP SYMPTOM CHART
| Diagnosis items | Symptom (Ignition switch ON) | Low tire pressure warning lamp | Cause | Action |
|---|---|---|---|---|
Low tire pressure warning lamp |
The low tire pressure warning lamp illuminates for 1 second, then turns OFF. | ![]() |
Wake-up operation for all tire pressure sensors at wheels is completed. | No system malfunctions |
| The low tire pressure warning lamp repeats blinking ON for 2 seconds and OFF for 0.2 seconds. | ![]() |
The all tire pressure sensor is not activated. | Perform the ID registration for all tire pressure sensors at wheels. Refer to Description. | |
| The low tire pressure warning lamp blinks once. | ![]() |
The front left tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at front left wheel. Refer to Description. | |
| The low tire pressure warning lamp repeats blinking twice. | ![]() |
The front right tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at front right wheel. Refer to Description. | |
| The low tire pressure warning lamp repeats blinking for 3 times. | ![]() |
The rear right tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at rear right wheel. Refer to Description. | |
| The low tire pressure warning lamp repeats blinking for 4 times. | ![]() |
The rear left tire pressure sensor is not activated. | Perform the ID registration for the tire pressure sensor at rear left wheel. Refer to Description | |
| The low tire pressure warning lamp turns ON and stays illuminated. | ![]() |
Low tire pressure | Check the tire pressure for all wheels and adjust to the specified value. Refer to TIRE AIR PRESSURE : Service Data. | |
| Low tire pressure warning lamp | The low tire pressure warning lamp repeats blinking at 0.5-second intervals for 1 minute, and then stays illuminated. | ![]() |
The combination meter fuse is open or removed (or pulled out). | Check and install the combination meter fuse. If necessary, replace the fuse. |
| The BCM harness connector is removed. | Check the connection conditions of the BCM harness connector, and repair if necessary. | |||
| Tire Pressure Monitoring System (TPMS) malfunction. |
|
Was this page helpful?







