Suspension

Tire Pressure Sensor

~4min read

Exploded View

Screw Tire pressure sensor Valve
Valve core Valve cap
: N·m (kg-m, in-lb)
: Always replace after every disassembly.
: Parts that are replaced as a set when the tire is replaced.

Removal & Installation

REMOVAL

Remove tire assembly. Refer to ROAD WHEEL TIRE : Removal & Installation.

Remove valve cap, valve core and then deflate tire.

Use the tire changer and disengage the tire beads.

Apply bead cream or an equivalent to the tire beads.

Turn tire so that valve hole is at bottom and bounce so that tire pressure sensor is near valve hole. Carefully lift tire onto turntable and position valve hole (and tire pressure sensor) 270° from mounting/dismounting head .

Remove mounting screw , and then remove tire pressure sensor from valve .

Cut the part of valve, using a pliers cutters (B).

Remove the valve from road wheel , using a valve inserter (A).

INSTALLATION

When reusing the tire pressure sensor, install the valve to the tire pressure sensor, follow the procedure below.Insert the tire pressure sensor to the roll pin of valve .

Install mounting screw .

Apply a suitable non-silicone lubricant to the surface of the valve that touches (A) the wheel and to the valve hole in the wheel.

Install the tire pressure sensor assembly, follow the procedure below.Set the tire pressure sensor assembly to road wheel.

Install the tire pressure sensor assembly to road wheel , using a valve inserter (A).

Apply bead cream or an equivalent to the tire beads.

Install the tire inside beads onto the road wheel in the position shown in the figure.

Set the tire onto the turntable so that the tire changer arm is at a position approximately 270° from the tire pressure sensor .

Install the tire outer side beads onto the road wheel.

Check the tire pressure for all wheels and adjust to the specified value. Refer to TIRE AIR PRESSURE : Service Data.

Install tire to the vehicle. Refer to ROAD WHEEL TIRE : Removal & Installation.

Perform "TIRE PRESSURE SENSOR ID REGISTRATION" when tire pressure sensor is removed and installed, or replaced. Refer to Work Procedure.