Suspension

Road Wheels & Tires

~4min read

Inspection

APPEARANCE

Road Wheel

  • Check road wheel for deformation, cracks, corrosion and other damage.

  • Check wheel nuts for looseness by using torque wrench.

    Wheel nut tightening torque Refer to ROAD WHEEL TIRE : Exploded View.

Tire

  • Check entire circumference and both sides of each tire for deformation, cracks, scratch and other damage.

  • Check tire tread for wear and foreign matter such as nails and small rock.

  • Check that tire pressure is the specified value.

    Tire pressure Refer to TIRE AIR PRESSURE : Service Data.

Adjustment

BALANCING WHEELS (BONDING WEIGHT TYPE)

Preparation Before Adjustment

Using releasing agent, remove double-faced adhesive tape from the road wheel.

Wheel Balance Adjustment

  • If a tire balance machine has adhesion balance weight mode settings and drive-in weight mode setting, select and adjust a drive-in weight mode suitable for road wheels.

  • The details of the adjustment procedure are different for each model of wheel balancer. Therefore, refer to each instruction manual.

Set road wheel on tire balance machine using the center hole as a guide. Start the tire balance machine.

When inner and outer unbalance values are shown on the tire balance machine indicator, multiply outer unbalance value by 5/3 to determine balance weight that should be used. Select the outer balance weight with a value closest to the calculated value above and install to the designated outer position of, or at the designated angle in relation to the road wheel.

Indicated unbalance value × 5/3 = balance weight to be installed

Calculation example:

23 g (0.81 oz) × 5/3 = 38.33 g (1.35 oz) ⇒ 37.5 g (1.32 oz) balance weight (closer to calculated balance weight value)

Example:

36.2 ⇒ 35 g (1.23 oz)

36.3 ⇒ 37.5 g (1.32 oz)

Installed balance weight in the position.
  • When installing balance weight to road wheels, set it into the grooved area on the inner wall of the road wheel as shown in the figure so that the balance weight center is aligned with the tire balance machine indication position (angle) .

If calculated balance weight value exceeds 50 g (1.76 oz), install two balance weight sheets in line with each other as shown in the figure.

Start the tire balance machine again.

Install drive-in balance weight on inner side of road wheel in the tire balance machine indication position (angle).

Start the tire balance machine. Check that the inner and outer residual unbalance value is within the allowable unbalance value.

Allowable unbalance value
Dynamic (At flange) : Refer to ROAD WHEEL : Service Data.
Static (At flange) :Refer to ROAD WHEEL : Service Data.

ROAD WHEEL TIRE : Rotation

  • Follow the maintenance schedule for tire rotation service intervals. Refer to General Maintenance.

  • When installing the wheel, tighten wheel nuts to the specified torque. Refer to ROAD WHEEL TIRE : Exploded View.

  • Perform the "TIRE PRESSURE SENSOR ID REGISTRATION", after tire rotation. Refer to Work Procedure.