Suspension

Rear Lower Link and Coil Spring

~3min read

Exploded View

Frame Adjusting bolt Eccentric disc
Rear lower link Axle housing Lower rubber seat
Coil spring Upper rubber seat Upper spring seat
: Always replace after every disassembly.
: N·m (kg-m, ft-lb)

Removal and Installation

REMOVAL

Remove tires. Refer to ROAD WHEEL TIRE : Removal & Installation.

Remove wheel sensor and harness connector. Move wheel sensor in a place where it will not interfere with work. Refer to Removal and Installation.

Set suitable jack under rear lower link.

Loosen rear lower link mounting nuts (frame side).

Separate rear lower link from axle housing.

Lower suitable jack, and remove coil spring.

Remove lower rubber seat.

Remove upper spring seat mounting bolts, and remove upper spring seats and upper rubber seats.

Remove rear lower link mounting nut, eccentric disc, and adjusting bolt and then remove rear lower link.

Perform inspection after removal. Refer to Inspection and Adjustment.

INSTALLATION

Note the following, and install in the reverse order of removal.

  • Install coil spring by aligning lower end of coil spring with lower rubber seat as shown in the figure.

    Dimension (A) : 5 mm (0.20 in) or less
  • Perform final tighting of rear lower link by the following procedures.

    1. Measure between wheel center and fender arch (A).

    2. Set the wheel chocks on the front tires.

    3. Jack up the rear of the vehicle and set the rigid rack.

    4. Remove the rear tires.

    5. Set suitable jacks (A) on the left and right axle housings . (axle housing ball joint fastening part).

    6. Jack up the left and right axle housings until the vehicle no longer floats off the rigid rack (A).

    7. Measure between wheel center and fender arch (A).

    8. Tight the mounting nuts of rear lower link to the specified torque. Refer to Exploded View.

  • Perform inspection after installation. Refer to Inspection.

Inspection

INSPECTION AFTER REMOVAL

Check rear lower link, bushing and coil spring for deformation, crack, and damage. Replace it if necessary.

INSPECTION AFTER INSTALLATION

Check wheel alignment. Refer to Inspection.