Exterior
Back door finisher
In this manual: Exterior
~1min read
Exploded View

1. Rear view camera
2. Back door opener request switch 3. Emblem
4. Back door finisher
: Clip
: Pawl
: Do not reuse
Removal and Installation
REMOVAL
1. Remove back door trim. Refer to INT-35, "BACK DOOR LOWER FINISHER : Removal and Installation". 2. Remove back door finisher mounting nuts. 3. Disconnect license lamp, back door opener request switch and rear view camera harness connectors. 4. Remove harness grommet. 5. Disengage back door finisher fixing clips using a remover tool (A), and then remove back door finisher.6. Disengage fixing clips at both ends of back door finisher from inside of back door.
: Clip
CAUTION:
• Apply protect tape (B) on back door panel to protect the painted surface from damage.
• Never pull back door finisher strongly.

INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:When installing back door finisher, check that clip are securely in body panel holes, and press them in.
Was this page helpful?