Roof side molding
Exploded View

1. Roof side molding 2. Roof side molding clip 3. Double-sided tape [t: 2.5 mm (0.098 in)] 4. Body side outer panel 5. Roof panel
: Vehicle front
: Do not reuse
Removal and Installation
REMOVAL
ROOF SIDE MODLDING
1. Disengage roof side molding rear side fixing clip, using a remover tool (A).
: Clip
: Vehicle front
CAUTION:
Apply protective tape (B) on body to protect the painted surface from damage.

2. Pull up roof side molding from rear end to front end.
: Vehicle front
CAUTION:
Never pull the roof side molding strongly.

3. Disengage windshield molding and clip at the front end of roof side molding, and then remove while pulling out toward vehicle rear
: Clip

REMOVAL AND INSTALLATION OF ROOF SIDE MOLDING CLIP REMOVAL
1. Remove roof side molding.2. Heat adhesive tape interface using a dryer, and then peel roof side molding clips (body side) using longnose pliers.
CAUTION:Be careful not to damage the body.
INSTALLATION
1. Clean tape removed surface with a shop cloth soaked in white gasoline or IPA.2. Use two-part epoxy adhesive.
Adhesive : 3M-weld DP–100 or equivalent
3. Apply adhesive evenly to clip tape surface
Thickness : Approximately 0.5 mm (0.020 in)
4. Position applied parts to the proper location, and then sufficiently press-fit until the adhesive protrudes to tape side.
Press-fit limit : 19.6 N× 2 seconds
5. Tape roof side molding clips after press fit, and temporarily hold it for specified time based on the following.
5 to 10 °C : 1 hour or more 11 to 23 °C : 30 minutes or more 24 °C or more (75°F or more) : 15 minutes or more
CAUTION:• Use double-sided tape after hardening for roof side molding clips. • Securely insert molding rear end cap onto roof rear end cutout (installation standard). • When installing roof side molding of windshield glass portion, check that body side molding fastener is securely inserted and then press in.
• Never wash the vehicle within 24 hours so as to keep adhesive.