Transaxle & transmission CVT: RE0F10B
Calibration of decel G sensor
In this manual: Transaxle & transmission CVT: RE0F10B
~1min read
Description
TCM stores calibration data (inherent characteristic value) of G sensor to provide accurate control. Therefore, it is required to perform calibration of G sensor after the following work is performed.
• Removal/installation or replacement of G sensor • Replacement of TCM
Procedure
1.PREPARATION BEFORE CALIBRATION PROCEDURE 1. Park the vehicle on a level surface.2. Adjust air pressure of all tires to the specified pressure. WT-9, "Road Wheel".
>> GO TO 2.
2.PERFORM CALIBRATION
With CONSULT-III
1. Turn ignition switch ON.
CAUTION:Never start engine
.
2. Select “Work Support” in “TRANSMISSION”. 3. Select “G SENSOR CALIBRATION”.4. Touch “Start”.
CAUTION:Never swing the vehicle during “G sensor calibration”.
Is “COMPLETED” displayed? YES >> GO TO 3.
NO >> Perform steps 1 and 2 again.
3.PERFORM THE SELF-DIAGNOSIS
With CONSULT-III
1. Turn ignition switch OFF and wait for 10 seconds. 2. Turn ignition switch ON.
3. Select “Self Diagnostic Results” in “TRANSMISSION”.
Is “P1585” detected? YES >> Go to TM-236, "DTC Logic".
NO >> Calibration end
Was this page helpful?