Ignition coil, spark plug and rocker cover
Exploded View

1. Rocker cover protector 2. O-ring
3. PCV control valve
4. PCV hose
5. Clamp
6. Rocker cover gasket
7. Rocker cover
8. Clamp
9. PCV hose
10. Oil filler cap
11. Spark plug
12. Ignition coil
A. To air duct assembly B.Tightening must be done following the installation procedure.
Refer to EM-53
C. To turbocharger inlet tube
: N·m (kg-m, ft-lb)
: N·m (kg-m, in-lb)
: Always replace after every
disassembly.
Removal and Installation
REMOVAL
1. Drain engine coolant. Refer to CO-11, "Draining". 2. Remove engine cover. Refer to EM-25, "Exploded View". 3. Remove intake manifold. Refer to EM-28, "Exploded View". 4. Remove air inlet tube assembly. Refer to EM-31, "Exploded View". 5. Remove PCV hose. 6. Remove rocker cover protector.7. Disconnect ignition coil harness connector, and them remove ignition coil.
CAUTION:• Never drop or shock ignition coil.
• Never disassemble ignition coil.
8. Move ignition harness. 9. Remove rocker cover.• Loosen bolts in reverse order shown in the figure.
: Engine front

10. Remove PCV valve and PCV hose, if necessary.
11. Remove rocker cover gasket from rocker cover.
INSTALLATION
1. Install the rocker cover gasket to rocker cover.
CAUTION:Check the gasket is not dropped. 2. Install rocker cover.
• Tighten bolts in two steps separately in numerical order as shown in the figure.
: Engine front
1st step : 2 N·m (0.20 kg-m,
17 in-lb)
2nd step : 8,3 N·m (0.85 kg-m, 74
in-lb)
3. Install in the reverse order of removal, for the rest of parts.
