Transmission & Driveline
Drive Pinion Oil Seal
In this manual: Transmission & Driveline
~1min read

| Rear final drive assembly | Drive pinion oil seal | Electric controlled coupling assembly | |||
| Oil seal lip | |||||
REMOVAL
Drain gear oil. Refer to Draining.
Remove electric controlled coupling assembly. Refer to Removal and Installation.
Remove drive pinion oil seal using oil seal remover (commercial service tool).
INSTALLATION
Install drive pinion oil seal (1) using Tool (A).

| Oil seal installation length (D) | : 0.8 – 1.2 mm (0.031 – 0.047 in) |
| Tool number | : ST35271000 ( — ) |
Install electric controlled coupling assembly. Refer to Removal and Installation.
Refill gear oil to the final drive. Refer to Refilling.
Perform inspection after installation. Refer to Inspection.
INSPECTION
INSPECTION AFTER INSTALLATION
Check surface for cracks, leaks, or damage.
Replace any defective parts.
Check oil level and final drive for oil leakage. Refer to Inspection.
Was this page helpful?