Driver Controls
Led Headlamp
In this manual: Driver Controls
3steps
~18min
2/5difficulty
Done 0 of 3
CHECK HEADLAMP (LO) GROUND CIRCUIT
Ignition switch OFF.
Disconnect front combination lamp connector.
Check continuity between front combination lamp harness connector and ground.
Front combination lamp — Continuity Connector Terminal RH E243 5 Ground Yes LH E247
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair or replace harness.
CHECK LED HEADLAMP CONTROL MODULE
Install the normal LED headlamp control module to the applicable headlamp. Check that the lighting switch is turned ON.
Is the headlamp turned ON?
YES>>Replace LED headlamp control module. Refer to Removal and Installation.
NO>>GO TO 3.
CHECK HEADLAMP
Install the normal applicable front combination lamp. Check that the headlamp is turned ON.
Is the headlamp turned ON?
YES>>Replace front combination lamp. Refer to Removal and Installation.
NO>>LED headlamp is normal. Check headlamp control system.
Was this page helpful?