Driver Controls

Parking Lamp Circuit

13steps
~78min
3/5difficulty
Done 0 of 13
Component Function Check

CHECK PARKING LAMP OPERATION

CONSULT

  1. Select “EXTERNAL LAMPS” in “Active Test” mode of “IPDM E/R”.

  2. While operating the test items, check that the parking lamp is turned ON.

    TAIL : Parking lamp ON
    Off : Parking lamp OFF

Is the inspection result normal?

YES>>

Parking lamp circuit is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK PARKING LAMP FUSE

  1. Ignition switch OFF.

  2. Check that the following fuse is not blown:

    ComponentLocationFuse No.Capacity
    Parking lamps IPDM E/R 52 10 A
    Front side marker lamps IPDM E/R

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK PARKING LAMP CIRCUIT

  1. Disconnect the following connectors:

    • IPDM E/R

    • Front combination lamp LH

    • Front combination lamp RH

    • Rear combination lamp LH (back door side)

    • Rear combination lamp RH (body side)

  2. Check continuity between IPDM E/R harness connector and ground.

    IPDM E/R—Continuity
    ConnectorTerminal
    E218 90 Ground No
    E121 9

Is the inspection result normal?

YES>>

Replace fuse. (Replace IPDM E/R if blown fuse is found again).

NO>>

Replace the blown fuse after repairing the affected circuit.

CHECK PARKING LAMP

Check applicable LED lamp.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Replace applicable LED lamp.

CHECK PARKING LAMP OUTPUT VOLTAGE

CONSULT

  1. Disconnect front combination lamp connector.

  2. Ignition switch ON.

  3. Select “EXTERNAL LAMPS” in “Active Test” mode of “IPDM E/R”.

  4. While operating the test items, check voltage between IPDM E/R harness connector and ground.

    (+)(−)Test item

    Voltage

    (Approx.)
    IPDM E/R
    ConnectorTerminal
    E218 90 Ground EXTERNAL LAMPS TAIL Battery voltage
    Off 0 V

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Replace IPDM E/R. Refer to Removal and Installation.

CHECK PARKING LAMP POWER SUPPLY CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect IPDM E/R connector.

  3. Check continuity between IPDM E/R harness connector and front combination lamp harness connector.

    Front combination lampIPDM E/RContinuity
    ConnectorTerminalConnectorTerminal
    RH E243 3 E218 90 Yes
    LH E247

Is the inspection result normal?

YES>>

GO TO 6.

NO>>

Repair or replace harness.

CHECK PARKING LAMP GROUND CIRCUIT

Check continuity between front combination lamp harness connector and ground.

Front combination lamp—Continuity
ConnectorTerminal
RH E243 7 Ground Yes
LH E247

Is the inspection result normal?

YES>>

Check corresponding lamp socket and harness. Repair or replace if necessary.

NO>>

Repair or replace harness.