Driver Controls

Luggage Room Lamp

10steps
~60min
3/5difficulty
Done 0 of 10
Component Function Check
  • Battery saver output/power supply circuit

  • Luggage room lamp bulb

CHECK LUGGAGE ROOM LAMP OPERATION

CONSULT

  1. Ignition switch ON.

  2. Select “TRUNK/LUGGAGE LAMP TEST” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.

  3. While operating the test items, check that luggage room lamp turns ON/OFF.

    On : Luggage room lamp ON
    Off : Luggage room lamp OFF

Does the luggage room lamp turn ON/OFF?

YES>>

Luggage room lamp circuit is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK LUGGAGE ROOM LAMP OUTPUT

  1. Ignition switch OFF.

  2. Disconnect luggage room lamp connector.

  3. Check continuity between BCM harness connector and ground.

BCM — Condition Continuity
Connector Terminal
M20 85 Ground Back door Open Yes
Closed No

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Continuity exists and remains unchanged: GO TO 3.

NO>>

Continuity does not exist and remains unchanged: Replace BCM. Refer to Removal and Installation.

CHECK LUGGAGE ROOM LAMP OPEN CIRCUIT

  1. Disconnect BCM connector.

  2. Check continuity between BCM harness connector and luggage room lamp harness connector.

    BCMLuggage room lampContinuity
    ConnectorTerminalConnectorTerminal
    M20 85 B26 2 Yes

Is the inspection result normal?

YES>>

Replace luggage room lamp. Refer to Removal and Installation.

NO>>

Repair or replace harnesses.

CHECK LUGGAGE ROOM LAMP SHORT CIRCUIT

  1. Disconnect BCM connector.

  2. Check continuity between BCM harness connector and ground.

    BCM — Continuity
    Connector Terminal
    M20 85 Ground No

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harnesses.