Driver Controls

Push-Button Ignition Switch Illumination Circuit

14steps
~84min
3/5difficulty
Done 0 of 14
Component Function Check

CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION OPERATION

CONSULT

  1. Ignition switch ON.

  2. Select “ENGINE SW ILLUMI” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.

  3. While operating the test items, check that the push-button ignition switch illumination turns ON/OFF.

    On : Push-button ignition switch illumination ON
    Off : Push-button ignition switch illumination OFF

Does the push-button ignition switch illumination turn ON/OFF?

YES>>

Push-button ignition switch illumination circuit is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

Provides the power supply and the ground to control the push-button ignition switch illumination.

CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION OPERATION

CONSULT

  1. Ignition switch ON.

  2. Select “ENGINE SW ILLUMI” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.

  3. While operating the test item, check voltage between push-button ignition switch connector.

(+) (-) Test item

Voltage

(Approx.)
Push-button ignition switch Ground ENGINE SW ILLUMI
Connector Terminal
M208 5 ON 5 V
OFF 0 V

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

GO TO 2.

CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION POWER SUPPLY OPEN CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect BCM harness connector and the push-button ignition switch harness connector.

  3. Check continuity between BCM harness connector and the push-button ignition switch harness connector.

BCMPush-button ignition switchContinuity
ConnectorTerminalConnectorTerminal
M19 48 M208 5 Yes

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connectors.

CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION POWER SUPPLY SHORT CIRCUIT

Check continuity between BCM harness connector and ground.

BCM — Continuity
Connector Terminal
M19 48 Ground No

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.

CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION GROUND CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect push-button ignition switch harness connector.

  3. Check continuity between push-button ignition switch harness connector and ground.

    Push-button ignition switch — Continuity
    Connector Terminal
    M208 6 Ground Yes

Is the inspection result normal?

YES>>

Replace push-button ignition switch. Refer to Removal and Installation.

NO>>

GO TO 5.

CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION GROUND OPEN CIRCUIT

  1. Disconnect BCM harness connector and push-button ignition switch harness connector.

  2. Check continuity between BCM harness connector and push-button ignition switch harness connector.

    Push-button ignition switch BCM Continuity
    Connector Terminal Connector Terminal
    M208 6 M80 107 Yes

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.