Driver Controls

Map Lamp Circuit

14steps
~84min
4/5difficulty
Done 0 of 14
Description

Controls the lamp (ground side) by PWM signal (duty) when the map lamp main switch is DOOR.

Component Function Check
  • Battery saver output/power supply circuit

  • Front room/map lamp assembly

CHECK MAP LAMP CONTROL FUNCTION

CONSULT

  1. Ignition switch ON.

  2. Switch map lamp main switch DOOR.

  3. Select “DR SEAT LAMP TEST” or “AS SEAT LAMP TEST” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.

  4. While operating the test items, check map lamps operation.

    Test itemOperation
    DR SEAT LAMP TEST On

    Map lamp

    (driver side)
    ON
    Off OFF
    AS SEAT LAMP TEST On

    Map lamp

    (passenger side)
    ON
    Off OFF

Are the map lamps turned ON/OFF?

YES>>

Map lamp circuit is normal.

NO>>

Refer to Diagnosis Procedure.

Diagnosis Procedure

CHECK MAP LAMP CONTROL OUTPUT

CONSULT

  1. Ignition switch ON.

  2. Switch map lamp main switch DOOR.

  3. Select “DR SEAT LAMP TEST” or “AS SEAT LAMP TEST” in “Active Test” mode of “BCM(INTELLIGENT KEY)”.

  4. While operating the test items, check voltage between BCM harness connector and ground.

    Driver side
    BCM — Test item

    Voltage

    (Approx.)
    Connector Terminal
    M19 47 Ground DR SEAT LAMP TEST On 0 V
    Off Battery voltage
    Passenger side
    BCM — Test item

    Voltage

    (Approx.)
    Connector Terminal
    M19 46 Ground AS SEAT LAMP TEST On 0 V
    Off Battery voltage

Is the inspection result normal?

Yes>>

GO TO 2.

Fixed OFF>>

Replace BCM. Refer to Removal and Installation.

Fixed ON>>

GO TO 3.

CHECK MAP LAMP CONTROL CIRCUIT FOR OPEN

  1. Ignition switch OFF.

  2. Disconnect the BCM and front room/map lamp assembly connector.

  3. Check continuity between the BCM harness connector and front room/map lamp assembly harness connector.

    BCMFront room/map lamp assemblyContinuity
    ConnectorTerminalConnectorTerminal
    Driver side M19 47 R6 4 Yes
    Passenger side 46 5

Is the inspection result normal?

YES>>

Replace the front room/map lamp assembly. Refer to Removal and Installation.

NO>>

Repair the harnesses or connectors.

CHECK MAP LAMP CONTROL CIRCUIT FOR SHORT

  1. Ignition switch OFF.

  2. Disconnect the BCM and front room/map lamp assembly connector.

  3. Check continuity between the BCM harness connector and ground.

    BCM — Continuity
    Connector Terminal
    Driver side M19 47 Ground No
    Passenger side 46

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair the harnesses or connectors.