Driver Information & Multimedia
Steering Switch
In this manual: Driver Information & Multimedia
4steps
~24min
2/5difficulty
Done 0 of 4
CHECK STEERING SWITCH CIRCUIT
Ignition switch OFF.
Disconnect combination meter harness connector and spiral cable harness connector.
Check continuity between combination meter harness connector and spiral cable harness connector.
Combination meter Spiral cable Continuity Connector Terminal Connector Terminal M24 21 M41 2 Yes 22 4 23 3 Check continuity between combination meter harness connector and ground.
Combination meter — Continuity Connector Terminal M24 21 Ground No 22 23
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connector.
CHECK STEERING SWITCH RESISTANCE
Check resistance between the following steering switch terminals:
| Steering switches | Condition | Resistance (Ω) (Approx.) | ||
|---|---|---|---|---|
| Terminals | Signal name | |||
| 32 | 33 | Display | Depress |
2023 |
| Back | Depress |
723 | ||
| 31 | Enter | Depress OK switch. | 2023 | |
| Menu Up | Depress |
121 | ||
| Menu Down | Depress |
321 | ||
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace steering wheel switch. Refer to Removal and Installation.
CHECK SPIRAL CABLE
Check continuity between the following spiral cable terminals:
| Spiral cable | Continuity | |
|---|---|---|
| Terminals | ||
| 31 | 4 | Yes |
| 32 | 3 | |
| 33 | 2 | |
Is the inspection result normal?
YES>>Inspection End.
NO>>Replace spiral cable. Refer to Removal and Installation.
Was this page helpful?