Driver Information & Multimedia
U1000 Can Comm Circuit
In this manual: Driver Information & Multimedia
3steps
~18min
2/5difficulty
Done 0 of 3
Refer to System Description.
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1000 | CAN COMM CIRCUIT (CAN COMM CIRCUIT) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | - | ||
| Threshold | When combination meter is not transmitting or receiving CAN communication signals. | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
CAN communication system
FAIL-SAFE
The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.
Refer to Fail-safe.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON and wait for 2 seconds or more.
Select “Self Diagnostic Result” mode of “METER/M&A”.
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Refer to Intermittent Incident.
CHECK CAN COMMUNICATION SYSTEM
Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.
>>Inspection End.
Was this page helpful?