Driver Information & Multimedia
U1010 Control Unit(can)
In this manual: Driver Information & Multimedia
3steps
~18min
2/5difficulty
Done 0 of 3
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1010 | CONTROL UNIT (CAN) [CONTROL UNIT (CAN)] |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | - | ||
| Threshold | - | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
Combination meter
FAIL-SAFE
The combination meter activates the fail-safe control if CAN communication with each unit is malfunctioning.
Refer to Fail-safe.
PERFORM SELF DIAGNOSTIC RESULT
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “METER/M&A”.
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>Refer to Intermittent Incident.
REPLACE COMBINATION METER
Replace combination meter. Refer to Removal and Installation.
>>Inspection End.
Was this page helpful?