Transmission & Driveline

Transaxle Side

~3min read
Removal and Installation

REMOVAL

Remove drive shaft. Refer to Removal and Installation (LH) (LH) or Removal and Installation (RH) (RH).

Secure front drive shaft in a vise.

Remove boot bands and slide boot back.

Put matching marks on housing and shaft before separating housing.

Remove stopper ring using a suitable tool.

Pull out housing.

Put matching marks (A) on spider assembly and shaft.

Remove snap ring (1) using a suitable tool.

Remove spider assembly from shaft.

Remove boot from shaft.

Remove circular clip from housing.

Remove dust shield from housing.

Clean old grease off slide joint housing.

INSPECTION AFTER REMOVAL

Shaft

Check shaft for cracks or damage. Replace entire drive shaft if necessary.

Housing and Spider Assembly

Check housing and spider assembly for scratches or wear. Replace entire drive shaft if necessary.

Boot

Check boot for cracks, damage, and leakage of grease. Replace boot if necessary.

INSTALLATION

Install new boot and new small boot band on shaft.

Remove protective tape wound around serrated part of shaft.

Align matching mark (A) on spider assembly (1) with matching mark on shaft (2). Install spider assembly to shaft with chamfer (B) facing shaft.

Secure spider assembly onto shaft with snap ring (1) using a suitable tool.

Assemble housing onto spider assembly making sure to align matching marks made during disassembly, and fill with specified amount of new Genuine NISSAN Grease.

Grease quantity : Refer to Drive Shaft.

Install new stopper ring to housing.

After installation, pull shaft to check engagement between housing and stopper ring.

Install boot securely into grooves (indicated by "*" marks) as shown.

Make sure boot installation length (L) is length specified below. Insert a suitable tool into large end of boot. Bleed air from boot to prevent boot deformation.

Boot installation length (L) : Refer to Drive Shaft.

Install new large and small boot bands securely using Tool.

Tool number : KV40107300 (J-51751)

Dimension (M) : Refer to Boot Bands.

Install new dust shield to housing.

Install new circular clip to housing.

After installing housing and shaft, make sure boot position is correct. If boot position is not correct, remove old boot bands then reposition boot and secure with new boot bands.

Install drive shaft. Refer to Removal and Installation (LH) (LH) or Removal and Installation (RH) (RH).