Engine oil

In this manual: Engine oil
Air bags, seat belts and child restraints — 1Exterior front — 1Exterior rear — 1Passenger compartment — 1Instrument panel — 1Engine compartment check locations — 1Seats — 1Head restraints/headrests — 1Seat belts — 1Child safety — 1Child restraints — 1Supplemental Restraint System (SRS) — 1Instrument panel — 1Meters and gauges — 1Warning lights, indicator lights and audible reminders — 1Security systems (if so equipped) — 1Wiper and washer switch — 1Rear window defroster switch — 1Headlight and turn signal switch — 1Horn — 1Vehicle Dynamic Control (VDC) off switch — 1Power outlets — 1Storage — 1Windows — 1Interior lights — 1Keys — 1Doors — 1Remote keyless entry system (if so equipped) — 1NISSAN Intelligent Key (if so equipped) — 1Hood — 1Trunk lid — 1Fuel-filler door — 1Steering wheel — 1Sun visors — 1Mirrors — 1Control panel buttons - color screen with Navigation System (if so equipped) — 1RearView Monitor (if so equipped) — 1Vents — 1Heater and Air Conditioner (manual) — 1Servicing air conditioner — 1Audio system — 1NissanConnectSM Mobile Apps (if so equipped) — 1Car phone or CB radio — 1Bluetooth Hands-Free Phone System without Navigation System (Type A) (if so equipped) — 1Bluetooth Hands-Free Phone System without Navigation System (Type B) (if so equipped) — 1Bluetooth Hands-Free Phone System with Navigation System (if so equipped) — 1NISSAN Voice Recognition System (if so equipped) — 1Precautions when starting and driving — 1Ignition switch (if so equipped) — 1Push-button ignition switch (if so equipped) — 1Before starting the engine — 1Starting the engine (models without NISSAN Intelligent Key system) — 1Starting the engine (models with NISSAN Intelligent Key system) — 1Driving the vehicle — 1Parking brake — 1Cruise control (if so equipped) — 1Break-in schedule — 1Fuel efficient driving tips — 1Increasing fuel economy — 1Parking/parking on hills — 1Power steering — 1Brake system — 1Vehicle Dynamic Control (VDC) system (if so equipped) — 1Cold weather driving — 1Hazard warning flasher switch — 1Flat tire — 1Jump starting — 1Push starting — 1If your vehicle overheats — 1Towing your vehicle — 1Cleaning exterior — 1Cleaning interior — 1Corrosion protection — 1Maintenance precautions — 1Engine compartment check locations — 1Engine cooling system — 1Engine oil — 1Continuously Variable Transmission (CVT) fluid (if so equipped) — 14-speed automatic transmission fluid (ATF) (if so equipped) — 1Power steering fluid — 1Brake and clutch (if so equipped) fluid — 1Windshield-washer fluid — 1Battery — 1Variable voltage control system (if so equipped) — 1Drive belt — 1Spark plugs — 1Air cleaner — 1Windshield wiper blades — 1Brakes — 1Fuses — 1Battery replacement — 1Lights — 1Wheels and tires — 1Maintenance requirements — 1General maintenance — 1Explanation of scheduled maintenance items — 1Maintenance schedules — 1Standard maintenance — 1Maintenance under severe operating conditions — 1Recommended fluids/lubricants and capacities — 1Specifications — 1When traveling or registering in another country — 1Vehicle identification — 1Installing front license plate — 1Vehicle loading information — 1Towing a trailer — 1Uniform tire quality grading — 1Emission control system warranty — 1Reporting safety defects — 1Readiness for inspection/maintenance (I/M) test — 1Event Data Recorders (EDR) — 1Owner's Manual/Service Manual order information — 1
~4min read

Checking engine oil level

Checking engine oil level

1. Park the vehicle on a level surface and apply the parking brake.

2. Start the engine and let it idle until it reaches operating temperature.

3. Turn off the engine. Wait more than 10 minutes for the oil to drain back into the oil pan.

4. Remove the dipstick and wipe it clean. Reinsert it all the way.

Checking engine oil level

5. Remove the dipstick again and check the oil level. It should be between the H (High) and L (Low) marks B . This is the normal operating oil level range. If the oil level is below the L (Low) mark A , remove the oil filler cap and pour recommended oil through the opening. Do not overfill C .

6. Recheck oil level with the dipstick.

It is normal to add some engine oil between oil maintenance intervals depending on the severity of operating conditions or depending on the property of the engine oil used. More engine oil is consumed by frequent acceleration/deceleration especially when the engine rpm is high. Consumption is likely to be higher when the engine is new. If the rate of oil consumption, after driving for 3,000 miles (5,000 km), is more than 0.5 liter per 600 miles (1,000 km), consult a NISSAN dealer

CAUTION

Oil level should be checked regularly. Operating the engine with an insufficient amount of oil can damage the engine, and such damage is not covered by warranty.

Changing engine oil

Changing engine oil

1. Park the vehicle on a level surface and apply the parking brake.

2. Start the engine and let it idle until it reaches operating temperature, then turn it off.

3. Remove the oil filler cap A by turning it counterclockwise.

4. Place a large drain pan under the drain plug B .

5. Remove the drain plug B with a wrench by turning it counterclockwise and completely drain the oil.

If the oil filter is to be changed, remove and replace it at this time. For additional information, refer to "Changing engine oil filter" in this section.

WARNING

  • Prolonged and repeated contact with used engine oil may cause skin cancer.
  • Try to avoid direct skin contact with used oil. If skin contact is made, wash thoroughly with soap or hand cleaner as soon as possible.
  • Keep used engine oil out of reach of children.

CAUTION

  • Be careful not to burn yourself. The engine oil may be hot.
  • Waste oil must be disposed of properly.
  • Check your local regulations.

6. Clean and reinstall the drain plug B and a new washer. Securely tighten the drain plug B with a wrench. Do not use excessive force.

Drain plug tightening torque: 25 ft-lb (34 N*m)

7. Refill engine with recommended oil through the oil filler opening, then install the oil filler cap A securely.

For additional information on drain and refill capacity, refer to "Recommended fluids/lubricants and capacities" in the "Technical and consumer information" section of this manual.

The drain and refill capacity depends on the oil temperature and drain time. Use these specifications for reference only. Always use the dipstick to determine when the proper amount of oil is in the engine.

8. Start the engine. Check for leakage around the drain plug B and oil filter. Correct as required.

9. Turn the engine off and wait more than 10 minutes. Check the oil level with the dipstick. Add engine oil if necessary.

Changing engine oil filter

Changing engine oil filter

1. Park the vehicle on a level surface and apply the parking brake.

2. Turn the engine off.

3. Place a large drain pan under the oil filter B .

4. Loosen the oil filter with an oil filter wrench by turning it counterclockwise. Then remove the oil filter by turning it by hand.

CAUTION

Be careful not to burn yourself. The engine oil may be hot.

5. Wipe the engine oil filter sealing surface with a clean rag.

CAUTION

Be sure to remove any old gasket material remaining on the sealing surface of the engine. Failure to do so could lead to engine damage.

6. Coat the gasket on the new filter with clean engine oil .

7. Screw on the oil filter until a slight resistance is felt, then tighten an additional 2/3 turn.

Oil filter tightening torque: 13 ft-lbs (18 N*m)

8. Start the engine and check for leakage around the oil filter. Correct as required.

9. Turn the engine off and wait more than 10 minutes. Check the oil level. Add engine oil by removing the oil filler cap A if necessary.