Wheel arch

INTRODUCTION

Replacing this part is a complementary operation to replacing the wing side (pillar inner panel) for a frontal collision.

It also requires replacing the upper wing side reinforcements (pillar inner panel), and the use of the repair bench.

In the operation below, you will only find descriptions of the connections specific to the part concerned.

Information on other parts is covered in their respective sections.

PART COMPOSITION M.P.R.

Part assembled with:

• engine mount extension (right side),

• engine mount plate (right side),

• wheel arch,

• shock absorber cup,

• shock absorber cup riser,

• ABS bracket (right side),

• injection unit and crash sensor bracket (left side).

LINKED WITH:

Heater bulkhead
Side member closing panel
Front side member
Lower front crossmember

PARTS CONCERNED (thickness in mm):

1. 1

   Shock absorber cup riser 1

2. 2

   Engine mount extension 1.5

3. 3

   Engine mount reinforcement 1.5

4. 4

   Shock absorber cup 2

5. 5

   Heater bulkhead 1

6. 6

   Side member closing panel 1

7. 7

   Front side member front section 1.5

8. 8

   Front side member rear section 2.5

9. 9

   Front wheel arch 1

10. 10

    Front lower crossmember end 1.5

11. 11

    Injection unit and crash sensor bracket (left side) 2