Renault Megane Quiz
Chassis

Interpreting states

In this manual: Chassis
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
~1min read
ET017 BRAKE PEDAL

INSTRUCTIONS

Note: Carry out the checks only if the "pressed" and "released" states are inconsistent with the position of the pedal.

"Released" STATE, brake pedal pressed.

If the stop lights work:
  • Check and ensure continuity of the wiring between pin 1 of the brake switch connector and pin 20 of the control unit connector.

If the stop lights do not work:

  • Check the condition and installation of the brake switch as well as the brake light fuse.
  • Remove and test the operation of the brake switch
Interprétation des états
  • Replace the brake switch if necessary.
  • Check and confirm the ignition-switched + (after ignition) is present on pin 2 of the brake switch connector.

"Pressed" STATE, brake pedal released.

  • Check the condition and installation of the brake switch as well as the brake light fuse.
  • Remove and test the operation of the brake switch:
Interprétation des états
  • Replace the brake switch if necessary.
  • Check and ensure the wiring between pin 1 of the brake switch connector and pin 20 of the control unit connector is insulated from 12 V.

AFTER REPAIR

Carry out a road test followed by a check with the diagnostic tool.

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.