BSD (Blind-Spot Detection) / LCA (Lane Change Assist)

Operating Conditions

To operate:

Press the BSD switch when the Engine Start/Stop button is in the ON position. The indicator on the switch illuminates. If the vehicle speed exceeds 30 km/h, the system is activated.

To cancel:

Press the BSD switch again. The indicator on the switch turns off.

If the system is not in use, turn the system off by pressing the switch.

NOTICE

• If the engine is turned off and then on again, the system returns to its previous state.
• When the system is on, the warning light illuminates for 3 seconds on the outside rearview mirror.

Warning Type

The system is activated when:

1. The system is turned on.

2. Vehicle speed is above approximately 30 km/h.

3. Other vehicles are detected behind.

If a vehicle is detected within the system's detection zone, the warning light on the outside rearview mirror illuminates.

If the detected vehicle is not within the warning range, the warning will be deactivated according to the driving conditions.

Second-Stage Warning

The second-stage warning is activated when:

1. The first-stage signal is on.
2. The turn signal light is turned on to change lanes.

When the second-stage warning is activated, the warning indicator on the outside rearview mirror will flash and the chime will sound.

If you turn off the turn signal, the second-stage warning will be deactivated.

Radar Detection

The radar sensors are located inside the rear bumper.

Always keep the rear bumper clean for the system to function properly.

Warning Message

• This warning message may appear when:

- One or both sensors on the rear bumper are blocked by mud, snow, or a foreign object
- Driving in rural areas where the BSD sensor does not detect another vehicle for an extended period of time
- In adverse weather conditions such as heavy snow or rain

When any of these conditions occur, the indicator on the BSD switch and the system will turn off automatically.

When the BSD cancellation warning message is displayed in the cluster, check that there is no mud or snow on the rear bumper in the areas where the sensors are located. Remove any mud, snow, or foreign material that may interfere with the radar sensors.

After removing any dirt or debris, the BSD system should operate normally after approximately 10 minutes of driving.

If the system still does not operate normally, have the vehicle inspected by an authorized HYUNDAI dealer.

If the system does not operate properly, a warning message will appear and the indicator on the switch will turn off. The system will turn off automatically. Have your vehicle inspected by an authorized HYUNDAI dealer.