Rear Upper Arm Repair Procedures

Replacement

1. 1
   Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the wheel cap (A).

   

   Be careful not to damage the wheel cap (A) when removing it.

3. 3
   Remove the front wheel and tire (A) from the front hub.

   Tightening torque: 88.3 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the front wheel and tire (A).

4. 4
   Remove the upper arm (A) by loosening the bolt and nut on the rear bracket.

   Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

   

   Install a transmission jack under the lower arm to remove the shock absorber with the suspension unloaded.

5. 5
   Loosen the bolt and nut, then remove the rear upper arm (A) from the rear subframe.

   Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

   

   Install a transmission jack under the lower arm to remove the shock absorber with the suspension unloaded.

6. 6
   Installation is the reverse of removal.

Inspection

1. 1
   Inspect the bushing for wear and damage.
2. 2
   Check that all bolts and nuts are present.