Rear Shock Absorber Repair Procedures

Replacement

1. 1
   Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the wheel cap (A).

   

   Be careful not to damage the wheel cap (A) when removing it.

3. 3
   Remove the front wheel and tire (A) from the front hub.

   Tightening torque: 88.3 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the front wheel and tire (A).

4. 4
   Loosen the mounting bolt and nut. Then separate the shock absorber from the lower arm.

   Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

   

   Install a transmission jack under the lower arm to remove the shock absorber with the suspension unloaded.

5. 5
   Loosen the shock absorber mounting bolts (A).

   Tightening Torque: 49.0 ~ 64 N·m

   

6. 6
   Installation is the reverse of removal.

Inspection

1. 1
   Inspect the rubber components for wear and deterioration.
2. 2
   Compress and extend the piston rod (A) and check for abnormal resistance or unusual noise during operation. Disposal

   1. Fully extend the piston rod.
   2. Drill a hole in the section (A) to release the gas from the cylinder.

      

      The exhaust gas is harmless, but be careful of chips that may be generated while drilling.