Rear Coil Spring Repair Procedures

Replacement

1. 1
   Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the wheel cap (A).

   

   Be careful not to damage the wheel cap (A) when removing it.

3. 3
   Remove the front wheel and tire (A) from the front hub.

   Tightening torque: 88.2 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the front wheel and tire (A).

4. 4
   Remove the rear lower arm cover.

   

5. 5
   Loosen the lower arm mounting bolt and nut (A). Then remove the lower arm from the rear bracket.

   Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

   

   Install a transmission jack under the lower arm to remove the shock absorber with the suspension unloaded. Record the alignment mark positions before removing the rear lower arm to prevent tightening the bolt and washer in the wrong position or direction.

6. 6
   Loosen the mounting bolt and nut. Then separate the shock absorber from the lower arm.

   Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

   

   Install a transmission jack under the lower arm to remove the shock absorber with the suspension unloaded. Record the alignment mark positions before removing the rear lower arm to prevent tightening the bolt and washer in the wrong position or direction.

7. 7
   Loosen the lower arm mounting bolt and nut properly from the subframe. Pull the lower arm downward, then remove the coil spring (A).

   Tightening Torque: 107.9 ~ 118 N·m

   

8. 8
   Installation is the reverse of removal.
9. 9
   Check the rear wheel alignment. (Refer to Rear Suspension System - Wheel Alignment)

Inspection

1. 1
   Check the spring for deformation, aging, or damage.
2. 2
   Check the upper and lower spring seats for wear or damage.