Ect sensor removal and installation

1. 1
   Remove the left side cowling. Refer to “exterior parts removal and installation” in section 9d .
2. 2
   Drain engine coolant. Refer to “cooling system inspection” in section 0b .
3. 3
   Disconnect the coupler and remove the ect sensor (1).

take special care when handling the ect sensor. It may cause damage if it gets an excessive impact.

Install the ect sensor in the reverse order of removal.

Pay attention to the following points:

• tighten the ect sensor (1) to the specified torque.

Caution use new gasket washer to prevent engine coolant leakage.

• Pour engine coolant. Refer to “cooling system inspection” in section 0b .