Isc valve preset and opening initialization

When removing or replacing the isc valve, set the isc valve to the following procedures:

1. 1
   turn the ignition switch on.
2. 2
   Set up the sds tool. (Refer to the sds operation manual for further details.)
3. 3
   Click the “active control”.
4. 4
   Click the “isc learned value reset” (1).

   

5. Click the “reset” button (2) to clear the isc leaned value.

Note the leaned value of the isc valve is set at preset position.

6. Close the sds tool and turn the ignition switch off.

the isc valve opening initialization is automatically started after the ignition switch is turned off position.

Refer to “dtc “c44” (p0130/p0135): ho2 sensor (ho2s) circuit malfunction” in section 1a (page 1a- 103).

Refer to “heated oxygen sensor (ho2s) removal and installation” in section 1b .

Refer to “side-stand / ignition interlock system parts inspection” in section 1i .

Refer to “gear position (gp) switch removal and installation” in section 5b .