Stp sensor adjustment

Adjust the stp sensor in the following procedures:

1. 1
   remove the air cleaner box cover. Refer to “air cleaner element removal and installation” in section 1d .
2. 2
   Disconnect the stva lead wire coupler (1).

   

1. 1
   Insert the needle pointed probes to the stp sensor coupler (between y/w and b/br wires).
2. 2
   Turn the ignition switch on.
3. 3
   Close the secondary throttle valve by finger and measure the stp sensor output voltage.

Special tool
(a): 09900–25008 (multi circuit
tester set)
(b): 09900–25009 (needle-point probe
set)

Tester knob indication voltage ( )

1. 1
   Move the throttle body upward by loosing the throttle body mounting screws.
2. 2
   Loosen the stp sensor mounting screw using the special tool and adjust the stp sensor until the output voltage comes within the specified value.

Special tool
: 09930–11950 (torx wrench (5 mm))

8. Tighten the stp sensor mounting screw to the specified torque.

9. Reinstall the removed parts.