Tp sensor adjustment

Inspect the tp sensor setting position and adjust it if necessary in the following procedures:

1. connect the special tool (mode select switch) to the dealer mode coupler. Refer to “self-diagnostic procedures” in section 1a .

Special tool
: 09930–82720 (mode selection switch)

1. 1
   Warn up the engine and keep it running in idling speed.
2. 2
   Turn the mode select switch on.
3. 3
   Check the position of the bar in the left of c code displayed on the lcd panel.

   

Incorrect position Correct position

1. 1
   If the tp sensor adjustment is necessary, turn off the engine and lift up the throttle body from the intake pipes. Refer to “throttle body removal and installation” in section 1d .
2. 2
   Loosen the tp sensor mounting screw using the special tool and turn the tp sensor to bring the bar to the correct position.

Special tool : 09930–11950 (torx wrench (5 mm))

7. Tighten the tp sensor mounting screw to the specified torque.

1. 1
   Reinstall the throttle body.
2. 2
   Turn on the engine and make sure that the tp sensor bar is at the correct position.
3. 3
   Turn off the engine and reinstall the removed parts.