ACC Signal Circuit

DESCRIPTION

This circuit detects the ignition switch ACC or off condition, and sends it to the main body ECU.

WIRING DIAGRAM
CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE

1. READ VALUE USING TECHSTREAM (IGNITION SWITCH)

(a) Using the Techstream, read the Data List (See page ).

Main Body

Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
ACC SW	Ignition switch ACC signal / ON or OFF	ON: Ignition switch ACC OFF: Ignition switch off	-

OK:

Normal conditions listed above are displayed.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

1. CHECK HARNESS AND CONNECTOR (BATTERY - MAIN BODY ECU)

(a) Remove the main body ECU (See page ).

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Switch Condition	Specified Condition
A-29 (ACC) - Body ground	Ignition switch ACC	11 to 14 V

Text in Illustration

*a	Front view of wire harness connector (to Main Body ECU)

OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR