Door Mirror Foot Light Circuit
The main body ECU controls the door mirror foot light.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
- Inspect the fuses for circuits related to this system before performing the following procedure.
PERFORM ACTIVE TEST USING TECHSTREAM (DOOR MIRROR FOOT LIGHT)
(a) Using the Techstream, perform the Active Test (See page .gif)
).
Main Body
Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
Side Mirror Foot Light |
Door mirror foot light |
ON/OFF |
- |
OK:
Door mirror foot light comes on.
| OK | .gif) | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
.gif)
CHECK HARNESS AND CONNECTOR (OUTER MIRROR - MAIN BODY ECU AND BODY GROUND)
(a) Disconnect the I4 and H4 outer mirror connectors.
(b) Disconnect the F10 main body ECU connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
for LH
Tester Connection | Condition | Specified Condition |
|---|---|---|
I4-1 (MLP) - F10-4 (MILE) |
Always |
Below 1 Ω |
I4-7 (MLP-) - Body ground |
Always |
Below 1 Ω |
I4-1 (MLP) - Body ground |
Always |
10 kΩ or higher |
for RH
Tester Connection | Condition | Specified Condition |
|---|---|---|
H4-1 (MLP) - F10-4 (MILE) |
Always |
Below 1 Ω |
H4-7 (MLP-) - Body ground |
Always |
Below 1 Ω |
H4-1 (MLP) - Body ground |
Always |
10 kΩ or higher |
| OK | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Test yourself
A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.