Power Source Mode does not Change to ON (IG)

When the engine switch is pushed with the key in the cabin, the power management control ECU receives signals to switch the power source mode.

Refer to "Power Source Mode does not Change to on (IG and ACC)" (See page ).

NOTICE:

• When using the Techstream with the engine switch off to troubleshoot: Connect the Techstream to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.
• Before performing the inspection, check that there are no problems related to the CAN communication system and LIN communication system.
• Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1. CHECK HARNESS AND CONNECTOR (BATTERY - POWER MANAGEMENT CONTROL ECU)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. INSPECT NO. 1 INTEGRATION RELAY (IG2 RELAY)

NG

REPLACE NO. 1 INTEGRATION RELAY

OK

1. INSPECT DRIVER SIDE JUNCTION BLOCK ASSEMBLY (IG1 NO. 1, IG1 NO. 2 AND IG1 NO. 3 RELAYS)

NG

REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)

OK

1. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - DRIVER SIDE JUNCTION BLOCK ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. CHECK HARNESS AND CONNECTOR (DRIVER SIDE JUNCTION BLOCK ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - NO. 1 INTEGRATION RELAY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. CHECK HARNESS AND CONNECTOR (NO. 1 INTEGRATION RELAY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. CHECK POWER MANAGEMENT CONTROL ECU

NG

REPLACE POWER MANAGEMENT CONTROL ECU

OK

1. CONFIRM TEST

OK

USE SIMULATION METHOD TO CHECK

NG

CHECK RELAY CONTACT SIDE CIRCUIT