Windows

Removal

~2min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) after parts are removed and installed or replaced during power window regulator motor removal/installation are shown below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Disconnect the negative (-) battery cable

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

  • Door Window Regulator Assembly
  • Power Window Regulator Motor Assembly
  • Door Glass
  • Door Glass Slider

Initialize Power Window Control System

  • Automatic Open and Close Function
  • Anti-Pinch Function
  • Anti-Pinch Function Operation
  • Remote Control Function
  • Key-Linked Function
  • Function Linked to Remote Control Transmitter
  • Keyless Operation
  • Power Window Open Warning Function

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. DISCONNECT NEGATIVE BATTERY CABLE

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

2. REMOVE REAR DOOR INSIDE HANDLE TRIM CLIP

Click here

3. REMOVE REAR POWER WINDOW SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL

Click here

4. REMOVE REAR DOOR REAR FRAME BRACKET

Click here

5. REMOVE REAR DOOR TRIM PANEL SUB-ASSEMBLY

Click here

6. REMOVE REAR DOOR GLASS INSIDE WEATHERSTRIP

Click here

7. REMOVE REAR DOOR BELT MOULDING

Click here

8. REMOVE REAR DOOR BELTLINE REAR SEAL

Click here

9. REMOVE REAR DOOR SERVICE HOLE COVER

Click here

10. REMOVE REAR DOOR FRAME GARNISH

Click here

11. REMOVE REAR DOOR GLASS SLIDER

Click here

12. REMOVE THE REAR DOOR GLASS LOWER REAR FRAME SUB-ASSEMBLY

Click here

13. REMOVE THE REAR DOOR GLASS SUB-ASSEMBLY

Click here

14. REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY

Click here

15. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a TORX T25 socket wrench, remove the 3 screws and the rear power window regulator motor assembly.