Windows

Removal

~3min read

REMOVAL

PRECAUTION / NOTICE / HINT

The procedures required (adjustment, calibration, initialization or registration) after parts are removed and installed or replaced during power window regulator motor removal/installation are shown below.

Procedures Required After Replacement / Removal / Installation of Parts

Replaced Part or Performed Procedure

Required Procedure

Effect/Inoperative Function When Required Procedure Is Not Performed

Link

Disconnect the negative (-) battery cable

Initialize Back Door Lock

Door Lock Control System

Memorize Steering Angle Neutral Point

Lane Departure Alert System (with Steering Control)

Pre-Collision System

  • Door Window Regulator Assembly
  • Power Window Regulator Motor Assembly
  • Door Glass
  • Door Glass Slider

Initialize Power Window Control System

  • Automatic Open and Close Function
  • Anti-Pinch Function
  • Anti-Pinch Function Operation
  • Remote Control Function
  • Key-Linked Function
  • Function Linked to Remote Control Transmitter
  • Keyless Operation
  • Power Window Open Warning Function

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. PRECAUTIONS

NOTICE:

After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.

Click here

2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL CLIP

Click here

4. REMOVE MULTIPLEX NETWORK MAIN SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Click here

5. REMOVE POWER WINDOW SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Click here

6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here

7. REMOVE FRONT DOOR GLASS INNER SEAL

Click here

8. REMOVE FRONT DOOR CENTER BELT WEATHERSTRIP

Click here

9. REMOVE FRONT DOOR ACCESS HOLE COVER

Click here

10. REMOVE FRONT DOOR WINDOW GLASS SUB-ASSEMBLY

Click here

11. REMOVE FRONT DOOR ACCESS HOLE COVER NO. 2

Click here

12. REMOVE FRONT DOOR WINDOW REGULATOR ASSEMBLY

Click here

13. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Using a TORX T25 socket wrench, remove the 3 screws and the rear power window regulator motor assembly.