Windows

Installation

~2min read
010203040505.44N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.

(b) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

HINT:

When replacing the power window regulator motor assembly, a new front power window regulator motor assembly uses tapping screws to thread the new installation holes when the tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Click here

3. INSTALL FRONT DOOR ACCESS HOLE COVER NO. 2

Click here

4. INSTALL FRONT DOOR WINDOW GLASS SUB-ASSEMBLY

Click here

5. INSTALL FRONT DOOR ACCESS HOLE COVER

Click here

6. INSTALL FRONT DOOR CENTER BELT WEATHERSTRIP

Click here

7. INSTALL FRONT DOOR GLASS INNER SEAL

Click here

8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here

9. INSTALL POWER WINDOW SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for front passenger side)

Click here

10. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for driver side)

Click here

11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL CLIP

Click here

12. DISCONNECT NEGATIVE BATTERY TERMINAL CABLE

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

13. INITIALIZE POWER WINDOW CONTROL SYSTEM

Click here

14. CHECK POWER WINDOW OPERATION

Click here