Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) after removing and installing the parts, or replacing parts when removing/installing the front seat belt outer belt assembly, are indicated below.
Procedure Required After Replacing / Removing / Installing PartsReplaced Part or Performed Procedure | Required Procedure | Effect/Inoperative Function When Required Procedure Is Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Memorize Steering Angle Neutral Point |
||
Pre-Collision System |
CAUTION:
Some service operations affect the SRS airbag system. Before starting any service operation, carefully read the precautions for the SRS airbag system.
Click here![]()
HINT:
- Repeat the same procedure for the right side and the left side.
- The procedure described below applies to the LH side.
PROCEDURE
1. PRECAUTIONS
NOTICE:
After turning the ignition switch OFF, a waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, be sure to read the precautions for disconnecting the cable from the negative (-) battery terminal before performing the work.
Click here
![]()
2. DISCONNECT THE CABLE FROM THE NEGATIVE BATTERY TERMINAL
Click here![]()
CAUTION:
- Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
- If any Supplemental Restraint System (SRS) component is accidentally deployed, serious injury may result.
NOTICE:
When the cable has been disconnected, some systems must be reset after the cable is reconnected.
Click here
![]()
3. REMOVE REAR BENCH SEAT ASSEMBLY
Click here![]()
4. REMOVE FRONT DOOR SILL PLATE
Click here![]()
5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
(a) Detach the front door opening trim weatherstrip.
6. REMOVE REAR DOOR SILL PLATE (without rear seat side airbag)
Click here![]()
7. REMOVE REAR DOOR SILL PLATE (with rear seat side airbag)
Click here![]()
8. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
(a) Disconnect the rear door opening trim weatherstrip.
9. REMOVE OUTER SEAT BELT SHOULDER ANCHOR COVER
(a) Release the claws and the guide to remove the outer seat belt lap anchor cover as shown in the illustration.
![]() |
Remove in this direction |
10. DISCONNECT FRONT SEAT BELT OUTER BELT ASSEMBLY
(a) Remove the bolt to disconnect the floor anchor of the front seat belt outer belt assembly. |
![]() |
11. REMOVE LOWER CENTER PILLAR GARNISH
Click here![]()
12. REMOVE CENTER PILLAR GARNISH ASSEMBLY
Click here![]()
13. REMOVE FRONT SEAT BELT OUTER BELT ASSEMBLY
(a) Remove the nut to disconnect the upper anchor of the front seat belt outer belt assembly. |
![]() |
(b) Using a screwdriver with its tip wrapped in protective tape, pull out the lock button to release the lock and disconnect the pretensioner connector as shown in the illustration. |
|
(c) for front passenger seat belt with selectable force limiter:
(1) Using a screwdriver with its tip wrapped in protective tape, pull out the lock button to release the lock and disconnect the selectable force limiter connector as shown in the illustration. |
|
(d) Remove the bolt. |
![]() |
(e) Release the guides to remove the front seat belt outer belt assembly.
14. REMOVE FRONT SEAT BELT UPPER ANCHOR ADJUSTER ASSEMBLY
(a) Remove the 2 bolts. |
![]() |
(b) Release the guide to remove the front seat belt upper anchor adjuster assembly.
.gif)
.png)





