Seat Belt

Installation

~3min read
0204060801004231N·mlb·ft
Tightening torque found on this page

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Repeat the same procedure for the right side and the left side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. INSTALL FRONT SEAT BELT UPPER ANCHOR ADJUSTER ASSEMBLY

(a) Engage the guide and temporarily install the front seat belt upper anchor adjuster assembly with the 2 bolts.

(b) Tighten the 2 bolts in the order shown in the illustration.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

2. INSPECT FRONT SEAT BELT OUTER BELT ASSEMBLY

Click here

3. INSTALL FRONT SEAT BELT OUTER BELT ASSEMBLY

(a) Engage the guides to install the front seat belt outer belt assembly.

(b) Install the bolt.

Torque:

12.5 N·m {127 kgf·cm, 9 ft·lbf}

(c) Connect the pretensioner connector and lock the lock button as shown in the illustration.

NOTICE:

Lock the lock button securely.

*a

Lock button

(d) for front passenger seat belt with selectable force limiter:

(1) Connect the selectable force limiter connector and lock the lock button as shown in the illustration.

NOTICE:

Lock the lock button securely.

*a

Lock button

(e) Connect the upper anchor of the front seat belt outer belt assembly with the nut.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

(f) Install the bolt to the lower part of the retractor.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

(g) Make sure the emergency locking retractor (ELR) locks.

NOTICE:

The inspection must be performed with the front seat belt outer belt assembly installed in the vehicle.

(1) With the front seat belt outer belt assembly installed in the vehicle, make sure the belt locks when pulled quickly.

(h) Remove the bolt from the lower part of the retractor.

4. INSTALL CENTER PILLAR GARNISH ASSEMBLY

Click here

5. INSTALL LOWER CENTER PILLAR GARNISH

Click here

6. CONNECT FRONT SEAT BELT OUTER BELT ASSEMBLY

(a) Connect the floor anchor of the front seat belt outer belt assembly with the bolt.

Torque:

42 N·m {428 kgf·cm, 31 ft·lbf}

7. INSTALL SEAT BELT LAP ANCHOR OUTER COVER

(a) Engage the guide and the claws to install the outer seat belt lap anchor cover.

Install in this direction

8. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

(a) Connect the rear door opening trim weatherstrip.

9. INSTALL REAR DOOR SILL PLATE (without rear seat side airbag)

Click here

10. INSTALL REAR DOOR SILL PLATE (with rear seat side airbag)

Click here

11. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

(a) Connect the front door opening trim weatherstrip.

12. INSTALL FRONT DOOR SILL PLATE

Click here

13. INSTALL REAR BENCH SEAT ASSEMBLY

Click here

14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When the cable has been disconnected, some systems must be reset after the cable is reconnected.

Click here

15. PERFORM DIAGNOSTIC SYSTEM CHECK

Click here

16. CHECK SRS WARNING LIGHT

Click here