Removal
REMOVAL
PRECAUTION / NOTICE / HINT
The procedures required (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during ion generator (for front side) removal/installation are shown below.
Necessary Procedures After Parts Removal / Installation / ReplacementReplacement part or procedure | Necessary Procedures | Effects / Inoperative Function When Necessary Procedure Not Performed | Link |
|---|---|---|---|
Disconnect the cable from the negative (-) battery terminal. |
Initialize Back Door Lock |
Door Lock Control System |
|
Memorize Steering Angle Neutral Point |
Lane Departure Alert System (with Steering Control) |
||
Pre-Collision System |
CAUTION:
Some service operations affect the SRS airbag system. Before starting any service operation, carefully read the precautions for the SRS airbag system.
Click here![]()
PROCEDURE
1. REMOVE INSTRUMENT PANEL SAFETY PAD ASSEMBLY
Click here
![]()
2. REMOVE NO. 1 HEATER DAMPER DUCT SUB-ASSEMBLY
Click here
![]()
3. REMOVE ION GENERATOR SUB-ASSEMBLY
(a) Disconnect the connector. |
![]() |
(b) Remove the 2 screws and the ion generator sub-assembly with No. 1 ion generator bracket.
(c) Remove the 2 screws, the ion generator sub-assembly and the No. 1 ion generator bracket air duct sub-assembly. |
![]() |
.gif)

