Windshield wipers and windshield washer
Using the wiper control lever
Windshield wipers with adjustable intermittent operation
To select the wiper operating mode, use the lever as follows. When the switch is in the intermittent wiper position, the wiping interval can also be adjusted.
Intermittent windshield wiping
Low-speed windshield wiping
High-speed windshield wiping
Mist (single wipe)
The wiping interval can be adjusted when intermittent mode is selected.
- Increases the intermittent windshield wiping frequency
- Decreases the intermittent windshield wiping frequency

- Washer with automatic wiping
After the washer fluid is sprayed, the wipers sweep the windshield 2 or 3 times.
Vehicles equipped with headlight washers: When the headlights are on and you pull the control lever toward you and hold it, the headlight washers operate once. After that, the headlight washers operate every 5 times you pull the control lever toward you.

Windshield wipers with rain sensor
When the selector is set to "AUTO", the wipers operate automatically when the sensor detects raindrops. The system then automatically adjusts the wiper speed according to the amount of rain and the vehicle speed.
Rain-sensor-controlled wiping
Low-speed windshield wiping
High-speed windshield wiping
Mist (single wipe)
When the selector is set to "AUTO", the rain sensor sensitivity can be adjusted by simply turning the selector ring as follows.
- Increases the windshield wiper sensitivity to rain
- Decreases the windshield wiper sensitivity to rain

- Washer with automatic wiping
After the washer fluid is sprayed, the wipers sweep the windshield 2 or 3 times.
Vehicles equipped with headlight washers: When the headlights are on and you pull the control lever toward you and hold it, the headlight washers operate once. After that, the headlight washers operate every 5 times you pull the control lever toward you.

■ Windshield wiper and washer operating conditions
Vehicles without a smart entry & start system
The engine start switch is in the "ON" position.
Vehicles with a smart entry & start system
The engine start switch is in START mode.
■ Effects of vehicle speed on wiper operation (vehicles with rain-sensor windshield wipers) Even when the wipers are in "AUTO" mode, the wiping speed changes with vehicle speed whenever the washer is used (the wipers wipe again after a short pause to prevent streaking).
■ Rain sensor (vehicles with rain-sensor windshield wipers)
- The rain sensor detects the amount of rain.
The vehicle has an optical sensor. The sensor may not operate correctly when sunlight from sunrise or sunset strikes the windshield, or when insects or other debris are on the windshield.

- If you set the wiper control to "AUTO" while the engine start switch is in START mode, the wipers wipe once to confirm that "AUTO" mode is activated.
- If the rain sensor temperature is above 90°C (194°F) or below -15°C (5°F), the automatic mode may not operate. In this case, use the wipers in a mode other than "AUTO".
■ If the windshield washer does not operate If there is still washer fluid in the reservoir, check that the washer nozzles are not clogged.
WARNING■ Caution regarding the use of washer fluid In cold weather, do not use the washer fluid until the windshield has warmed up. The fluid may freeze on the windshield and impair visibility. This could cause a serious or fatal accident.
■ Caution regarding use of the wipers in "AUTO" mode (vehicles with rain-sensor windshield wipers) In "AUTO" mode, the windshield wipers may activate unexpectedly if you touch the sensor or if the windshield vibrates.
Take care that the windshield wipers do not pinch your fingers, etc.
NOTE■ When the windshield is dry Do not use the wipers, as they may scratch the windshield.
■ If the nozzle does not spray washer fluid You may damage the washer fluid pump if you keep pulling the control lever toward you.
■ If a nozzle becomes clogged In this case, contact a Toyota dealer, an authorized Toyota repairer, or any reliable repairer.
Do not try to clear it with a pin or other pointed object. The nozzle may be damaged.