Steering Column

Reassembly

~2min read

REASSEMBLY

PRECAUTION / NOTICE / HINT

NOTICE:

  • Do not drop the power steering ECU assembly, strike it with tools or subject it to impact.
  • If the power steering ECU assembly is subjected to impact, replace it with a new one.
  • Do not pull on the wire harness.
  • Keep moisture away from the power steering ECU assembly.
  • Do not loosen bolts that are not specified in the procedure.
  • Do not allow foreign matter to contaminate the power steering ECU assembly.

PROCEDURE

1. INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER

Click here

2. INSTALL POWER STEERING ECU ASSEMBLY

Click here

3. INSTALL STEERING LOCK ACTUATOR ASSEMBLY (with Smart Key System)

HINT:

When replacing the steering lock actuator assembly, refer to the registration section.

Click here

(a) Install the steering lock actuator assembly using the shear bolt.

(b) Tighten the shear bolt until its head breaks off.

4. INSTALL KEY INTERLOCK SOLENOID (without Smart Key System)

(a) Install the key interlock solenoid to the steering column upper bracket sub-assembly with the screw.

5. INSTALL STARTER OR IGNITION SWITCH ASSEMBLY (without Smart Key System)

(a) Install the ignition or starter switch assembly using the 2 screws.

6. INSTALL UNLOCK WARNING SWITCH ASSEMBLY (without Smart Key System)

(a) Engage the 2 claws to install the unlock warning switch assembly onto the upper steering column bracket assembly.

7. INSTALL IGNITION LOCK CYLINDER ASSEMBLY (without Smart Key System)

(a) Make sure that the ignition lock cylinder assembly is in the ACC position.

(b) Install the ignition lock cylinder assembly.

8. CHECK STEERING LOCK OPERATION (without Smart Key System)

(a) Make sure that the steering lock mechanism engages when the key is removed.

(b) Make sure that the steering lock mechanism disengages when the key is inserted and turned to the ACC position.

If there is a malfunction, replace the ignition lock cylinder assembly.

9. INSTALL STEERING COLUMN UPPER BRACKET WITH SWITCH ASSEMBLY (without Smart Key System)

(a) Install the steering column upper bracket with switch assembly using the tapered head bolt.

(b) Tighten the shear bolt until its head breaks off.

10. INSTALL TRANSPONDER KEY COIL (without Smart Key System)

Click here