Exterior Panels / Trim

Reassembly

~3min read

REASSEMBLY

PROCEDURE

1. INSTALL REAR SPOILER PROTECTOR NO. 1

HINT:

  • Perform the same procedure to install each rear spoiler protector No. 1.
  • When installing rear spoiler protector No. 1, heat the rear spoiler assembly with a heat lamp.
Heating Temperature

Item

Temperature

Rear spoiler assembly

20 à 30 °C

CAUTION:

  • Do not touch heated parts or the heat lamp. Touching them may cause burns.
  • Prolonged contact with heated parts may cause burns.

*a

Hot Surface

*b

Heat Lamp

NOTICE:

Do not overheat the rear spoiler assembly.

(a) Clean the surface of the rear spoiler assembly.

(1) Using a heat lamp, heat the surface of the rear spoiler assembly.

(2) Remove the double-sided adhesive tape from the rear spoiler assembly.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat lamp, heat the rear spoiler assembly.

(c) Remove the protective sheet from a new rear spoiler protector No. 1.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Install the rear spoiler protector No. 1, as shown in the illustration.

HINT:

Install the rear spoiler protector No. 1 along the line of the rear spoiler assembly.

*a

Line

2. INSTALL HIGH MOUNT STOP LIGHT CABLE ASSEMBLY

(a) Engage the guides to install the high mount stop light cable assembly.

3. INSTALL REAR SPOILER SIDE SUB-ASSEMBLY

(a) Engage the guide to install the rear spoiler retainer No. 5.

(b) Install the screw.

(c) Engage the guide and claws to install the rear side skirt sub-assembly, as shown in the illustration.

Install in this direction

4. INSTALL HIGH MOUNT STOP LIGHT ASSEMBLY

Click here

5. INSTALL REAR SPOILER PROTECTOR NO. 2

HINT:

  • Perform the same procedure to install each rear spoiler protector No. 2.
  • When installing rear spoiler protector No. 2, heat the rear spoiler with a heat lamp.
Heating Temperature

Item

Temperature

Rear spoiler assembly

20 à 30 °C

CAUTION:

  • Do not touch heated parts or the heat lamp. Touching them may cause burns.
  • Prolonged contact with heated parts may cause burns.

*a

Hot Surface

*b

Heat Lamp

NOTICE:

Do not overheat the rear spoiler assembly.

(a) Clean the surface of the rear spoiler assembly.

(1) Using a heat lamp, heat the surface of the rear spoiler assembly.

(2) Remove the double-sided adhesive tape from the rear spoiler assembly.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat lamp, heat the rear spoiler assembly.

(c) Remove the protective sheet from the new rear spoiler protector No. 2.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Install the rear spoiler protector No. 2, as shown in the illustration.

HINT:

Install the rear spoiler protector No. 2 along the line of the rear spoiler assembly.

*a

Line

6. INSTALL REAR SPOILER NO. 2

(a) Engage the claws to install the rear spoiler No. 2, as shown in the illustration.

Install in this direction

(b) Reinstall the 2 screws.