Exterior Panels / Trim

Installation

~3min read

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

When installing the model designation plates, heat the back door outer garnish and model designation plates using a heat light.

Heating Temperature

Item

Temperature

  • Tailgate outer garnish
  • Model designation plate

20 à 30 °C

CAUTION:

  • Do not touch heated parts or the heat lamp. Touching them may cause burns.
  • Prolonged contact with heated parts may cause burns.

*a

Hot Surface

*b

Heat Lamp

NOTICE:

Do not overheat the vehicle body, back door outer garnish or model designation plate.

PROCEDURE

1. INSTALL TAILGATE EMBLEM NO. 1

(a) Clean the surface of the tailgate outer garnish.

(1) Using a heat lamp, heat the surface of the tailgate outer garnish.

(2) Remove the remaining double-sided tape from the back door outer garnish.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat light, heat the back door outer garnish and the new back door emblem No. 1.

(c) Remove the protective sheet from the back door emblem No. 1.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Engage the 2 pins and install the back door emblem No. 1 as shown in the illustration.

2. INSTALL BACK DOOR MODEL DESIGNATION PLATE NO. 1

(a) Clean the surface of the tailgate outer garnish.

(1) Using a heat lamp, heat the surface of the tailgate outer garnish.

(2) Remove the remaining double-sided tape from the back door outer garnish.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat light, heat the back door outer garnish and a new back door model designation plate No. 1.

(c) Remove the protective sheet from the back door model designation plate No. 1.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Install the back door model designation plate No. 1 as shown in the illustration.

*a

Specification

-

-

Standard measurement:

Area

Measurement

Area

Measurement

A

57.0 mm (2.24 in.)

B

85.5 mm (3.37 in.)

C

83.2 mm (3.28 in.)

-

-

3. INSTALL BACK DOOR MODEL DESIGNATION PLATE NO. 2

(a) Clean the surface of the tailgate outer garnish.

(1) Using a heat lamp, heat the surface of the tailgate outer garnish.

(2) Remove the remaining double-sided tape from the back door outer garnish.

(3) Remove any adhesive residue using a cleaning agent.

(b) Using a heat light, heat the back door outer garnish and a new back door model designation plate No. 2.

(c) Remove the protective sheet from the back door model designation plate No. 2.

HINT:

After removing the release liner, prevent the adhesive surface from contacting foreign matter.

(d) Install the back door model designation plate No. 2 as shown in the illustration.

*a

Specification

-

-

Standard measurement:

Area

Measurement

Area

Measurement

A

65.1 mm (2.56 in.)

B

113.7 mm (4.48 in.)