Wiper / Washer

Inspection

~1min read

INSPECTION

PRECAUTION / NOTICE / HINT

CAUTION:

During the test, be careful not to get your fingers or clothing caught between the moving parts.

PROCEDURE

1. INSPECT WIPER MOTOR ASSEMBLY

(a) Check LO operation.

(1) Apply battery voltage to the front windshield wiper motor assembly connector and check the speed of the front windshield wiper motor assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 5 (+1)

Battery negative (-) → Terminal 4 (E)

The motor operates at low speed

*a

Component without wire harness connected

(front windshield wiper motor assembly)

(b) Check HI operation.

(1) Apply battery voltage to the front windshield wiper motor assembly connector and check the speed of the front windshield wiper motor assembly.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → Terminal 3 (+2)

Battery negative (-) → Terminal 4 (E)

The motor operates at high speed

If the result is not as specified, replace the front windshield wiper motor assembly.