Doors / Back Door

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT FUEL FILLER DOOR OPENER SWITCH

(a) Check the resistance.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Ignition switch position

Specified Condition

4 (IG) - 1 (E)

Pressed (ON)

Below 1 Ω

4 (IG) - 1 (E)

Not pressed (OFF)

10 kΩ minimum

If the result is not as specified, replace the fuel filler door opener switch.

*a

Component without wire harness connected

(fuel filler door opener switch)

(b) Check that the LED lights up.

(1) Apply battery voltage to the fuel filler door opener switch and check that the LED lights up.

OK:

Measurement Condition

Specified Condition

Battery positive (+) → 3 (ILL+)

LED lights up

Battery negative (-) → 2 (ILL-)

If the result is not as specified, replace the fuel filler door opener switch.

*a

Component without wire harness connected

(fuel filler door opener switch)