Toyota Land Cruiser Quiz
Transfer

Inspection

In this manual: Transfer
Introduction — 13Preparation — 19Service specifications — 19Engine Mechanical — 28Automatic Transmission — 22Body Electrical — 373Brake — 34Propeller Shaft — 7Transfer — 24Motor shift control system — 1Steering — 34Ignition — 7Charging — 9Emission Control — 6Cooling — 17Starting — 12Lubrication — 13Maintenance — 7Chassis — 1Disassembly — 1
~1min read

1. INSPECT DRIVEN ROTOR BODY CLEARANCE

INSPECT DRIVEN ROTOR BODY CLEARANCE
(a) Install the drive rotor and driven rotor to the rear extension housing.

(b) Using a feeler gauge, measure the body clearance between the drive rotor and extension housing.

Standard clearance: 0.08 - 0.17 mm (0.0031 - 0.0067 in.) Maximum clearance: 0.17 mm (0.0067 in.)

If the body clearance exceeds the maximum, replace the drive rotor and driven rotor.

2. INSPECT DRIVEN ROTOR TIP CLEARANCE

INSPECT DRIVEN ROTOR TIP CLEARANCE

Using a feeler gauge, measure the tip clearance between the drive rotor and driven rotor.

Standard clearance: 0.05 - 0.15 mm (0.0020 - 0.0059 in.) Maximum clearance: 0.15 mm (0.0059 in.)

If the tip clearance exceeds the maximum, replace the drive rotor and driven rotor.

3. INSPECT OIL PUMP SIDE CLEARANCE

INSPECT OIL PUMP SIDE CLEARANCE

Using a steel straight edge and feeler gauge, measure the side clearance of oil pump.

Standard clearance: 0.03 - 0.10 mm (0.0012 - 0.0039 in.) Maximum clearance: 0.10 mm (0.0039 in.)

If the side clearance exceeds the maximum, replace the drive rotor and driven rotor.

Test yourself

A quick Toyota Land Cruiser quiz: every answer comes with an explanation and a link to the manual page.