Short in front passenger side squib 2nd step circuit

The front passenger side squib 2nd step circuit consists of the center airbag sensor and the front passenger airbag.

The circuit instructs the srs to deploy when the deployment conditions are met.

These dtcs are recorded when a malfunction is detected in the front passenger side squib 2nd step circuit.

• Perform the simulation method by selecting the "check mode" (signal check) with the intelligent tester (see page rs-52).
• After selecting the "check mode" (signal check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city or rough road (see page rs-52).

1. Check front passenger airbag assembly (front passenger side squib 2nd step)

1. 1
   Turn the ignition switch off.
2. 2
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. 3
   Disconnect the connector from the front passenger airbag.
4. 4
   Connect the white wire side of sst to the instrument panel wire connector e.

• Do not forcibly insert sst into the terminals of the connector when connecting.
• Insert sst straight into the terminals of the connector.

1. 1
   Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
2. 2
   Turn the ignition switch on, and wait for at least 60 seconds.
3. 3
   Clear the dtcs (see page rs-49).
4. 4
   Turn the ignition switch off
5. 5
   Turn the ignition switch on, and wait for at least 60 seconds.
6. 6
   Check the dtcs (see page rs-49).

Dtcs other than dtc b1815, b1816, b1817, b1818 and 54 may be output at this time, but they are not related to this check.

1. 1
   Check connector
2. 2
   Turn the ignition switch off.
3. 3
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
4. 4
   Disconnect sst (resistance 2.1 Ù) from the instrument panel wire.
5. 5
   Check that the instrument panel wire connectors (on the front passenger side airbag) are not damaged.

3. Check instrument panel wire

1. 1
   Disconnect the connector from the center airbag sensor.
2. 2
   Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
3. 3
   Turn the ignition switch on.
4. 4
   Measure the voltage of the wire harness side connector.

Standard voltage

1. 1
   Turn the ignition switch off
2. 2
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. 3
   Measure the resistance of the wire harness side connector.

Standard resistance

1. 1
   Release the activation prevention mechanism built into connector b (see page rs-37).
2. 2
   Measure the resistance of the wire harness side connector.

Standard resistance

4. Check no. 2 Instrument panel wire

1. 1
   Disconnect the no. 2 Instrument panel wire connector from the instrument panel wire.
2. 2
   Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
3. 3
   Turn the ignition switch on.
4. 4
   Measure the voltage of the wire harness side connector.

Standard voltage

1. 1
   Turn the ignition switch off.
2. 2
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. 3
   Measure the resistance of the wire harness side connector.

Standard resistance