Short in front driver side - side squib circuit

The driver side - side squib circuit consists of the center airbag sensor and the front seat side airbag lh.

This circuit instructs the srs to deploy when the deployment conditions are met.

These dtcs are recorded when a malfunction is detected in the driver side - side squib circuit.

• Perform the simulation method by selecting the "check mode" (signal check) with the intelligent tester (see page rs-52).
• After selecting the "check mode" (signal check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city or rough road (see page rs-52).

1. Check front seat side airbag assembly lh (driver side - side squib)

1. 1
   Turn the ignition switch off.
2. 2
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. 3
   Disconnect the connector from the front seat side airbag lh.
4. 4
   Connect the black wire side of sst to connector e.

• Do not forcibly insert sst into the terminals of the connector when connecting.
• Insert sst straight into the terminals of the connector

1. 1
   Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
2. 2
   Turn the ignition switch on, and wait for at least 60 seconds.
3. 3
   Clear the dtcs (see page rs-49).
4. 4
   Turn the ignition switch off
5. 5
   Turn the ignition switch on, and wait for at least 60 seconds.
6. 6
   Check the dtcs (see page rs-49).

Dtcs other than dtc b1820, b1821, b1822, b1823 or 55 may be output at this time, but they are not related to this check.

1. 1
   Check connector
2. 2
   Turn the ignition switch off.
3. 3
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
4. 4
   Disconnect sst from the no. 1 Seat airbag wire.
5. 5
   Check that the floor wire connectors (on the driver side - side squib) are not damaged.

3. Check floor wire (driver side - side squib circuit)

1. 1
   Disconnect the connector from the center airbag sensor.
2. 2
   Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
3. 3
   Turn the ignition switch on.
4. 4
   Measure the voltage of the wire harness side connector.

Standard voltage

1. 1
   Turn the ignition switch off.
2. 2
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. 3
   Measure the resistance of the wire harness side connector.

Standard resistance

1. 1
   Release the activation prevention mechanism built into connector b (see page rs-37).
2. 2
   Measure the resistance of the wire harness side connector

Standard resistance

4. Check no. 1 Seat airbag wire

1. 1
   Disconnect the no. 1 Seat airbag wire connector from the floor wire.
2. 2
   Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
3. 3
   Turn the ignition switch on.
4. 4
   Measure the voltage of the wire harness side connector.

Standard voltage

1. 1
   Turn the ignition switch off.
2. 2
   Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. 3
   Measure the resistance of the wire harness side connector.

Standard resistance