Solar sensor circuit (driver side)

The solar sensor, which is installed on the upper side of the instrument panel, detects sunlight and controls the air conditioning auto mode. The output voltage from the solar sensor varies in accordance with the amount of sunlight. When the sunlight increases, the output voltage increases. As the sunlight decreases, the output voltage decreases.

The air conditioning amplifier detects changes in the output voltage from the solar sensor.

1. 1
   Read value of intelligent tester (solar sensor d side)
2. 2
   Connect the intelligent tester (with can vim) to the dlc3.
3. 3
   Turn the ignition switch on and turn the intelligent tester main switch on.
4. 4
   Select the item below in the data list, and read the value displayed on the intelligent tester.

   

1. Inspect solar sensor

1. 1
   Remove the solar sensor.
2. 2
   Measure the resistance of the sensor.
3. 3
   Connect the ohmmeter's positive (+) lead to terminal 1 and the negative (-) lead to terminal 3 of the solar sensor.

Standard resistance

The connection procedure for using a digital tester such as an electrical tester is shown above. When using an analog tester, connect the positive (+) lead to terminal 3 and the negative (-) lead to terminal 1 of the solar sensor.

• As the inspection light is moved away from the sensor, the voltage decreases.
• Use an incandescent light for the inspection. Position it about 30 cm (11.8 In.) From the solar sensor.

3. Check wire harness (solar sensor - air conditioning amplifier)

1. 1
   Disconnect the f1 sensor connector.
2. 2
   Disconnect the e37 amplifier connector.
3. 3
   Measure the resistance of the wire harness side connectors.

Standard resistance